|
|
 |
|
 
|
|
|
||||
 |
|||||
|
Topside
"D0" point Cut a wire 2 cm length, and solder one edge to "D0" Point. Kynar type wire is the best you can use. Caution: Do not pull the wire while it is connected to the pad, cause you may remove "D0" trace! Always test if the connection is steady. |
||
 |
Presolder
the pad on X-elixis LPC Connector. Don't worry about the plastic, cause it is made from Polymide, and can stand till 300 degrees! |
||
 |
Connect the other edge of the wire to the presoldered pad and... | ||
 |
....you
FINISHED, ONCE and for ALL! X-elixis LPC Connector is installed, and from now on, you can do everything you want with just Plug&Play actions! |
||
 |
|||
|
|
--- |
Alternative
"D0" point easy installation |
|
 |
|||
